Opim-Insulation Hanger Nail
On bright galvanized sheet, one side is adhesive and the other side is nailed.
It is used in many different application areas, such as air conditioning ducts, ventilation ducts, building curtain walls, roof-ceiling osb systems, building curtain concrete applications.
It is used for vertical installation of light insulation materials such as GLASSWOOL, ROCK WOOL, EPS, XPS, DRAIN BOARD, without using any additional equipment. The assembly process is terminated with a special galvanized clip.
The pressure sensitive insulation hanger pin establishes a permanent bond between the double-sided adhesive hotmelt tapes and the surface to which it will adhere.
Locks Insulation Material with Compression Clip Washer Attached to Suspension Pin Nail
It has flexibility of application in different lengths. It is produced in lengths of 40mm, 60mm, 80mm, 100mm, 120mm, 140mm.
Application
PLACES OF USE OF OPİM
Light insulation materials such as GLASS WOOL, ROCK WOOL, EPS, XPS, DRAIN BOARD;
- air conditioning ducts
- ventilation ducts
- Building facades
- In construction brick masonry application, fixing the plumb rope
- In roof-ceiling osb systems
- In curtain concrete applications where the building remains underground
- Partition wall plasterboard systems
- It is used in fixing other different detail solution application areas.
OPIM APPLICATION BENEFITS
- The pressure sensitive insulation hanger pin establishes a permanent bond between the double-sided adhesive hotmelt tapes and the surface to which it will adhere.
- Locks the Insulation material with the Compression Clip Washer Attached to the Suspension Pin Nail.
- It is very practical and can be applied quickly in terms of application. In order for OPİM to fully bond with the bonded surface, it is necessary to wait about 12-24 hours depending on the ambient temperature and detail, and then apply the material to be used on the nail.
- It is much more advantageous than other fixing systems that can create a thermal bridge without drilling holes in insulation materials.
- It ensures that the insulation material remains stable without being affected by thermal differences in ventilation ducts, fan coil lines, in all duct systems through which gas-liquid-air is passed, in all hot and cold running lines.
- It is very long lasting.
- It has flexibility of application in different lengths.
- It is produced in lengths of 40mm, 60mm, 80mm, 100mm, 120mm, 140mm.
